Verge flail mower W 2.2 m

£3,770.00

excluding VAT

SKU 35-WKL220 Category

Kellfri verge flail mowers have been designed to cut beside and behind the tractor and easily cut ditch edges and other difficult to reach places.

The mower’s chassis is made of 4 mm thick steel, and the side plate is 6 mm thick.

The machine’s cutting head can be angled 60° downwards and 90° upwards.

The verge flail mowers are equipped with – 

  • SKF bearings on the roller
  • openable rear flap
  • adjustable support roller
  • tiltable cutting head
  • hydraulic side shift adjustment.

The cutting height is adjusted by the support roller and skids and the adjustable support roller guarantees a correct cutting height on uneven ground.

The verge flail mower is fitted with 32 hammer flails and the hydraulic side shift adjustment enables you to shift the machine to the left or right.

The maximum side shift adjustment of the machine is 374 cm to the right from the mid-point of the tractor.

The mower has an openable flap which you can open when you know you are cutting or topping ground that generates a higher flow of material. This enables you to drive freely under the same conditions as with a closed flap and a normal flow of material. You save on fuel and reduce wear on the belts, and you can also operate at a higher speed, as the grass does not become twisted around the roller. 

The verge flail mower is supplied with PTO drive shaft, transmission oil and hydraulic hoses as standard.

The mower requires two double-acting hydraulic outlets on the tractor. The verge flail mower is supplied with four hydraulic ½ inch, quick coupling male hoses.

Some of the images show Verge flail mower W 1.8 m.

More Information
Working width 2200 mm
Chassis 4/6 mm steel
Engine Power 60 – 100 hp
Colour Green, powder coated
Belts 4 x BX51 Li1295
Cutting height 0 – 120 mm
L x W x H 2660 x 975 x 701 mm
Rotor speed at 540 rpm 2606 rpm
Rotor roller 127 mm ø, thickness 8 mm
Side shift adjustment Hydraulic. Max: 3740 mm to the right from the mid-point of the tractor.
Support roller 182 mm ø
Three-point linkage Cat 1 & 2
PTO speed 540 rpm
Weight 727 kg