Verge Flail Mower 1.8m


excluding VAT

The Kellfri verge flail mower has been designed for efficient cutting both behind and beside the tractor. With tiltable cutting head and hydraulic side shift adjustment it is suitable for both pastures and forest tracks with saplings. Ditch edges can be cut easily, median strips and other places that are difficult to reach can be maintained with ease.

  • 1.8m working width
  • Customised for 50-75 hp tractors
  • SKF bearings on the roller
  • Openable rear flap
  • Adjustable support roller and chain guards
  • Tiltable cutting head
  • Hydraulic side shift adjustment
  • Adjustable cutting height (0-120mm)
Cutting Height

The cutting height can be adjusted by the support roller and skids. The adjustable support roller guarantees a correct cutting height on uneven ground. The cutting height can be adjusted enabling you to cut the grass close to the ground and thus achieve a more level result. The grass is evened out and the remnants moulder away faster. The support roller has a scraping iron to keep the roller free from cut material. Hammer flails are fitted as standard but the mower is also adapted for Y-flails. There are 24 flails in total.


The gearbox has a freewheel for gentle shutdown of the mower. The mower has counter bar in the chassis to break up the grass more effectively.

Rear flap

The mower has an openable flap. You open the flap when you know you are cutting or topping ground that generates a higher flow of material. This enables you to drive freely under the same conditions as with a closed flap and a normal flow of material. You save on fuel and reduce wear on the belts, and you can also operate at a higher speed, as the grass does not become twisted around the roller. The grass is also spread more evenly.

Chain Guards

The front of the verge flail mower is fitted with chain guards that adapt to the substrate and protect both the tractor and the surroundings from stone chipping and grass spray.

Hydraulic Side Shift Adjustment

The hydraulic side shift adjustment enables you to shift the machine to the left or right. The hydraulic side shift adjustment enables you to drive with just one pair of wheels in the uncut area and cut closer to ditches, fences, etc. The maximum side shift adjustment of the machine is 334 cm to the right from the mid-point of the tractor.

Additional Information

The cutting head can be angled 90° upwards and 60° downwards.

The chassis is made of 4 mm thick steel, and the side plate is 6 mm thick.

Supplied with PTO drive shaft, transmission oil and hydraulic hoses (four hydraulic ½ inch, quick coupling male hoses) as standard.

The mower requires two double-acting hydraulic outlets on the tractor.

Machine Specification
  • Length 2260mm
  • Width 975 mm
  • Height 701mm
  • Weight 654 kg
  • Belts – 4x BX51 Li1295
  • Rotor Speed at 540 rpm  – 2606 rpm
  • Rotor roller – 127 mm ø, thickness 8 mm
  • Support roller – 182 mm ø
  • Three-point linkage – Cat 1 & 2
  • PTO speed – 540 rpm