Verge Flail Mower 1.4m

£2,390.00

excluding VAT

The verge flail mower from Kellfri has a working width of 1.4 m with rear flap and SKF ball bearings. This verge flail mower is robust and powerful, with tiltable cutting head and hydraulic side shift adjustment suitable for 40-70 hp tractors.

Designed for efficient cutting both behind and beside the tractor, the verge flail is ready to cut both pastures and tracks with saplings. Using the hydraulic side shift adjustment, ditch edges, median strips on roads and other difficult places to reach are easily cut and maintained.

Cutting height

Cutting height is adjusted between 0-120mm by the support roller and skids. The adjustable support roller guarantees a correct cutting height on uneven ground, enabling you to cut the grass close to the ground and thus achieve a more level result. The grass is evened out and the remnants moulder away faster. The support roller has a scraping iron to keep the roller free from cut material. 

Chain Guards

The front of the verge flail mower is fitted with chain guards that adapt to the substrate and protect both the tractor and the surroundings from stone chipping and grass spray.

Flails

The verge flail mower is fitted as standard with 18 hammer flails. Note, that mower is also adapted for Y-flails, which can be purchased additionally. 

Hydraulic Side Shift

The hydraulic side shift adjustment enables you to shift the machine to the right. The maximum side shift adjustment of the machine is 294 cm to the right from the mid-point of the tractor. The side shift adjustment means that you can cut at the side of your tractor and thereby reach ditch edges and the median strip of roads, which would otherwise be difficult to reach. The hydraulic side shift adjustment enables you to drive with just one pair of wheels in the uncut area and cut closer to ditches, fences, etc. 

Openable rear flap

The mower has an openable flap. You open the flap when you know you are cutting or topping ground that generates a higher flow of material. This enables you to drive freely under the same conditions as with a closed flap and a normal flow of material. You save on fuel and reduce wear on the belts, and you can also operate at a higher speed, as the grass does not become twisted around the roller. The grass is also spread more evenly.

Features

  • Openable rear flap
  • SKF bearings on roller
  • Adjustable support roller
  • Tiltable cutting head
  • Hydraulic side shift adjustment
  • Adjustable support roller and chain guards
  • Machine head can be angled 90° upwards and 60° downwards

Machine Specification

Working Width: 1400 mm
Chassis: 4/6 mm steel
Engine Power: 40 – 70 hp
Belts: 4 x BX51 Li1295
Cutting Height: 0 – 120 mm
Rotor Speed: at 540 rpm – 2606 rpm
Rotor Roller: 127 mm ø
Side Shift Adjustment: Hydraulic. Max: 2940 mm to the right from the mid-point of the tractor.
Support Roller: 182 mm ø
Three-Point Linkage: Cat 2
PTO Speed: 540 rpm

Supplied with

The verge flail mower is supplied with

  • PTO drive shaft
  • Transmission oil
  • Hydraulic hoses as standard (four hydraulic ½ inch, quick coupling male hoses).

The mower requires two double-acting hydraulic outlets on the tractor.